Flywheel For AP Twin Clutch

Be the first to write a review

Specifically made for use with most 7 1/4" (184mm) TWIN PLATE Race clutches.

EP Tuning have designed the lightest EN24 ALL steel flywheel available.

Special ring cut gear teeth enhance the strength and enable further machining of the outside lightening holes.

Ours has several advantages over any other flywheel.

It has a lowest inertia of mass than any other steel flywheel; constructed from the highest quality EN24T steel (most others are made from a softer EN8).

Especially stepped central spigot for absolute accurate centralisation (just one thousandth of an inch oversize can put the flywheel out of balance here).

Its trigger teeth are precisely machined to lower the outer rotational mass / weight.

This lighter outer ring reduces the rotating mass by around 25% over other LIGHTWEIGHT flywheels.

We have even machined the outer ring gear into the flywheel to make this the strongest yet lightest flywheel available for the K Series engine.

The flywheel is then strategically heat treated for ultimate strength and chemically blacked for corrosion resistance.

A lighter flywheel takes less power to turn, giving you a quicker throttle response; less mass to move means more power to your wheels. Tickover is not affected.

Standard Original Equipment flywheel weighs over 7 KG, most aftermarket “lightweight” flywheels weigh over 4.6 KG.

Ours weighs just ~3.3 KG and the extra 1.50 KG is saved from the more important OUTER edge.

Save your engine and buy the best available.

FITS ALL K SERIES, ELISE S1, S2, 340R and EXIGE WITH TWIN PLATE CLUTCH.