K Series Exedy Clutch & Flywheel Set

Be the first to write a review

Kit Includes Exedy 3 Piece Race Clutch, EP Tuning Lightweight Flywheel and Flywheel Bolts.

Exedy Race Clutch

The Exedy system is the ultimate street clutch available.

It will take up to 200 lb-ft / 270Nm of torque which is more than adequate for any normally aspirated K Series engine.

There is no clutch snatch and it is as driveable as any standard clutch system.

Supplied complete as Full 3 piece kit;

Exedy Pressure plate, Exedy Driven Plate and Exedy Release Bearing.

Eliseparts Lightweight Flywheel

The Lightest EN24 ALL steel flywheel available, similarly priced others are over 25% heavier.

Special ring cut gear teeth to enhance the strength and enable further machining of the outside lightening holes

Ours has several advantages over any other flywheel. It has a lowest inertia of mass than any other steel flywheel; constructed from the highest quality EN24T steel (Most others are a softer EN8).

Especially stepped central spigot for absolute accurate centralisation (just one thousandth of an inch oversize can put the flywheel out of balance here).

Its trigger teeth are precisely machined to lower the outer rotational mass/weight. This lighter outer ring reduces the rotating mass by around 25% over other LIGHTWEIGHT flywheels.

We have even machined the outer ring gear into the flywheel to make this the strongest yet lightest flywheel available for the ‘K’ Series engine.

The flywheel is then strategically heat treated for ultimate strength and chemically blacked for corrosion resistance.

A lighter flywheel takes less power to turn, giving you a quicker throttle response and less mass to move means more power to your wheels. Tick over is not affected.

Standard original equipment flywheel weighs over 7kg; most aftermarket lightweight flywheels weigh over 4.5kg.

Ours weigh only 3.5kg , the extra 1kg is saved from the more important OUTER edge.

Original equipment Flywheel Bolts also included.

NOTES ON FITMENT.

If you are installing this clutch with a new gearbox or an upgraded one (Quaife), you'll need to ensure the spline on the clutch plate can move freely on the shaft.

It may also be necassary to adjust the Clutch Master Cylinder push rod to increase the travel.

N.B. EXEDY Racing Clutch warranty is limited to the reimbursement or replacement of products which are deemed to have a material or design defect within 3,000 miles / 4,828km or 6 months from the date of purchase, whichever occurs first.